National representative in the World Foundry Organization

News · · 4 July 2017

Nearly fifty professionals attended the Microscopy Technical Workshop given by LEICA MICROSYSTEMS and IK4-AZTERLAN

The workshop “Microscopy: from Macro to Micro and from Micro to Nano“, organized by LEICA MICROSYSTEMS, IK4-AZTERLAN and the TABIRA Foundry Institute, brought together about 50 technicians from 25 companies, institutes and universities.

The session began with an introduction by LEICA MICROSYSTEMS of the terminology and basic concepts of the microscopy techniques, explaining the performance keys of macroscopy, magnifying and microscopy tools. As introduced, the macroscopic properties of materials depend on microscopic characteristics, both structural and compositional. Thus, the LEICA experts deepened in Digital Microscopy through practical examples, from image formation in microscopy, to new concepts in escalation and resolution. These microscopes are gaining popularity in production and quality assurance, control and analysis of failures, and research and development, as well as in other applications, especially for inspection, documentation and analysis, such as 2D and 3D measurements.

The team of experts continued through examples from Analytical Microscopy, which refers to the microanalysis, where a sample is illuminated with a beam of electrons, causing the emission of signals that will allow, once detected and analyzed, determining the elemental composition of the area where the light falls. It was seen how this procedure serves to analyze volumes or areas, advancing to the attendees a series of applications of microstructural analysis and chemical composition.

The IK4-AZTERLAN Metallurgical Research Center shared with the audience an interesting conference on practical techniques for analysis and characterization of materials using microscopy, giving practical keys for the selection of the optical equipment of analysis based on the analytical needs existing in every case.

Finally, the working session ended with a practical block of demonstrations, which allowed working with stereoscopic, metallographic and digital microscopes, as well as using 2D and 3D measurement and image acquisition software. In particular, there could be used a Leica S9i stereomicroscope, and a Leica DMS1000 and a Leica DVM6 digital microscopes.

In summary, a very participative technical seminar, with a high assessment of its contents given by the attending companies.