National representative in the World Foundry Organization

Technical library ·

Effects of pouring temperature and squeeze pressure on the properties of Al-8%Si alloy squeeze cast components

A. Raji & R. H. Khan

Abstract

This work was conducted to determine the optimum squeeze parameters for producing squeeze castings from the Al alloy and compare the properties of the squeeze castings with those of chill castings. Al alloy Squeeze castings were produced using squeeze pressures of 25-150MPa at steps of 25MPa with the alloy poured at 650oC, 700oC and 750oC for each of the indicated pressure into a die preheated to about 250oC. Squeeze time was maintained for 30 seconds.

It was found that for a specific pouring temperature, the grain size of squeeze cast products became finer; density and the mechanical properties were increased with increase in squeeze pressure to their maximum values while further increase in pressure did not yield any meaningful change in the properties. Squeeze cast sample properties were compared with those of chill cast samples. It was found that optimum pouring temperature of 700oC and squeeze pressure of 125MPa could be used to produce sound squeeze cast Al alloy components with aspect ratio (height-to-section thickness ratio) not greater than 2.5:1.