National representative in the World Foundry Organization

Technical library ·

Empirical model for tensile property prediction in cast and heat treated Al-Si-Cu-Mg alloys

J. Fang, H. D. Brody and J. E. Morral

Abstract

An empirical relation has been developed for Al-Si-Cu-Mg alloys to facilitate the computer aided design of casting and heat treatment processes that can be used to achieve specified tensile properties in critical locations of cast components. The empirical relation is one element of a collaborative program to develop, verify and market an integrated system of software, databases, and design rules to enable quantitative prediction and optimization of the heat treatment of aluminum castings to increase quality, increase productivity, reduce heat treatment cycle times and reduce energy consumption.

End-chilled cast plates were used to produce as-cast microstructures with secondary dendrite arm spacing (das) ranging from 20 micrometers to 70 micrometers and volumetric porosity (%P) ranging up to 1.2%. The nominal composition studied was Al-7%Si-3.5%Cu-0.33%Mg-0.5%Fe. Coupons cut from the cast plates were given solutionizing times (θS) from 0 to 32 hours, quenched, aged, machined into cylindrical test bars, and tested in tension. Ultimate tensile strength, yield strength, and % plastic elongation were recorded. Three parameters were selected to represent the casting and heat treating process conditions and the tensile strength (TS) was fit to an expression of the form ( ) d c P b das a TS S + ⋅ + + ⋅ + ⋅ = θ % 1 ln where , , , c b a and d are the adjustable parameters.

The measured tensile properties of newly cast plates were compared to the tensile properties predicted by the empirical model derived from the original set of cast plates. The slopes of the correlation curves are one with R2 > 0.95 for the compositions for which duplicate plates were cast.