Mould filling of melt in vertical centrifugal casting is a complex process, which is governed by a number of processing variables. In this paper, a complete analysis of mold filling process of melt in vertical centrifugal casting is accomplished by combining theoretical analysis, numerical simulation and experiments. Results show that the melt fills the cavity with varying cross-sectional area and inclined angle. The filling process is divided into two steps in vertical centrifugal casting: forward filling and back filling. The cross-sectional area decreases and the inclined angle increases with increasing of the rotational velocity during forward filling. Moreover, the filling process of liquid has been simulated based on SOLAVOF technique. The comparison between the experimental and the numerical results shows good agreement.
Full paper (PDF)
PDF · 221.02 KB · Document in English
The full paper is available to members of the institute only.
Log in to downloadDetails
AuthorsGuo Jingjie, Li Changyun, Wu Shiping, Fu Hengzhi
OrganisationHarbin Institute of Technology, Harbin, P.R.China
Event67th World Foundry Congress
TopicAdvanced simulation techniques
Document languageEnglish
Year2006