The sequence of phase precipitation during solidification of a 319-type aluminum alloy was studied by thermal analysis. Melts of the alloy with different Sr contents were prepared in a gas-heated furnace. The liquid metal was poured into graphite cups fitted with two thermocouples. Special attention was paid in the experimental setup in order to obtain cooling curves with low noise. Thermogram data were analyzed using the derivative of cooling curves. Experimental onset temperatures of phase precipitation were compared with simulation results obtained from ThermoCalc and data base Al-DATA V3. In these simulations, the Gulliver- Scheil model was employed to take into account the microsegregation developed during solidification. The simulation results are consistent with experimental data in the sense that the onset reaction temperatures calculated are generally higher than those experimentally measured.
Full paper (PDF)
PDF · 193.80 KB · Document in English
The full paper is available to members of the institute only.
Log in to downloadDetails
AuthorsM. Castro-Román, J. J. Montes-Rodríguez, M. Herrera-Trejo
OrganisationCINVESTAV Unidad Saltillo, Carr. Saltillo-Monterrey km 13, 25000 Saltillo,
Event67th World Foundry Congress
TopicLight alloys
Document languageEnglish
Year2006