National representative in the World Foundry Organization

Technical library ·

A study on semi solid squeeze forging of high strength brass

K. H. Choe, G. S. Cho, K. W. Lee, Y. J. Choi, K. Y. Kim and M. H. Kim

Abstract

The microstructures and mechanical properties of high strength brass made by semi solid squeeze forging were investigated and compared with those of conventionally hot forged product and gravity die castings. No shrinkage or gas hole was found in squeeze forgings. Fine equiaxed crystals developed at the center of squeeze forgings, while grains in the corner of squeeze forgings were elongated perpendicular to the pressure direction. The grains of squeeze forgings were smaller than those of hot forgings and gravity die castings. It is suggested that a rapid heat transfer condition due to applied pressure is responsible for grain refinement. Tensile and yield strengths of squeeze forgings were as high as those of hot forgings but elongation was positioned between that of hot forgings and gravity die castings.